Herpes Bladder Spasms

solder K-track

The new soldering station is me now succeeded in the soldering of the K-rails:

• the center conductor at the track end had previously been no problem
• the rail connector is also very easy
• to the rail somewhere to solder in between is a bit difficult, but it is I also

for the power supply even thick cables that would go for 230 V, used. There are no wires. For feedback somewhere in the middle of the track but it is a cable with wires, and not quite as thick.

is important to provide a high temperature. I have the same maximum temperature of 450 degrees taken. Then it takes at all, until the solder melts. And because it lasts so short, no plastic melts! Somewhere in the web has been recommended for a discharge of heat to ensure by means of a clamp. I think this is not necessary.



I use the solder that the miniature Wonderland in Hamburg is sold. I go because there is no compromise. Of course that's not exactly cheap ...




The station is Conrad: ST80-D SOLDERING STATION DIGITAL 80W, Item Number:.? 588600-62

model railway H0 M rklin Maerklin Roco Brawa Fleischmann LDT

Digital Labs Portable Dvd K715

successful electronics soldering of cables at the K-track

weekend I tried to solder my first cable at the K-track. Somehow, I've noticed, it's not quite that simple. So I've already bought the special solder from the Miniature Wonderland in Hamburg. At the center conductor I've done it very quickly (on the track end), but the rails themselves I have broken their teeth. is then described in relevant forums, that it should go to the rail connectors or high temerature (340 degrees)
Today I bought a soldering station, where you can adjust the temperature. 'm Curious if it works.

model railway H0 M have? Come rklin Maerklin Roco Brawa Fleischmann LDT

Psoriasis From Msterbation

helix

Bin after restarting the building and started my first helix. I bought rods, drill holes in plates, which I cut into rings. The plates rest on top of nuts and are also secured with a nut. I hope the millimeter to create the increase.
In the helix, four Railroad tracks parallel. I just hope that the innermost track has a radius not too small, that too great a slope.
When I'm done, I'll do extensive testing of course.
way: I would like with the coil of 40 cm (first record level for the staging yard) to about 160 cm high. At this height, I want to build a bridge to the other helix. Perhaps even higher, so you do not bend down. I decide to start later if I can estimate on my "construction site". This would mean any event, between two mountains in my model room.

model railway H0 M? Rklin Maerklin Roco Brawa Fleischmann LDT