Herpes Bladder Spasms

solder K-track

The new soldering station is me now succeeded in the soldering of the K-rails:

• the center conductor at the track end had previously been no problem
• the rail connector is also very easy
• to the rail somewhere to solder in between is a bit difficult, but it is I also

for the power supply even thick cables that would go for 230 V, used. There are no wires. For feedback somewhere in the middle of the track but it is a cable with wires, and not quite as thick.

is important to provide a high temperature. I have the same maximum temperature of 450 degrees taken. Then it takes at all, until the solder melts. And because it lasts so short, no plastic melts! Somewhere in the web has been recommended for a discharge of heat to ensure by means of a clamp. I think this is not necessary.



I use the solder that the miniature Wonderland in Hamburg is sold. I go because there is no compromise. Of course that's not exactly cheap ...




The station is Conrad: ST80-D SOLDERING STATION DIGITAL 80W, Item Number:.? 588600-62

model railway H0 M rklin Maerklin Roco Brawa Fleischmann LDT